-
Most Recent Three Posts
-
We used stained Luan to replace wall and ceiling panels. If you are on a budget, take the time to separate the panel from the insulation. Otherwise get some sheet foam and cut to fit. We used a pneumatic stapler to attach panels. Consider upgrading the cab over lighting whilst you have the panels off.
On a 1989 Dolphin, at assembly it appears the roof was put on after the walls were finished. We used a quarter-round on the transitions to hide any mis-match.
Cabinets come off pretty easily. Be sure to measure/mark/ identify where wiring penetrates panels. Take lots of pics!
-
Check with Dinosaur Electronics. They make custom boards for many furnace applications.
If you know the factory part number, they have an interchange data base. If not, you can search by manufacturers model number.
I have an unused Dinosaur UIB-L board kicking around the shop somewhere. If it’s a match it’s yours for postage.
-
Need recommendations: My furnace starts as it should but shuts off abruptly after 2 seconds of operation. I replaced the time delay sw and the limit sw to no avail. All wiring is correct. Blower performs robustly and burner lights immediately with good blue flame. I suspect the modual board is shutting the gas immediately. Do I need a new Modual board? If so any recommendations on source. My board p/n is 231741. I have a Suburban furnace model DD 17DSI. Thanking you in advance. Marse.
-
Forums
-
Toyota Motorhomes
-
- 52.7k
- posts
-
- 29.4k
- posts
-
- 9.5k
- posts
- Furnace
- By fred heath,
-
- 12.2k
- posts
-
- 8k
- posts
-
- 657
- posts
-
- 1.9k
- posts
-
- 680
- posts
-
- 840
- posts
-
- 268
- posts
-
- 1.1k
- posts
-
- 332
- posts
-
- 1.3k
- posts
-
- 1.6k
- posts
-
- 589
- posts
-
<u>Toyotamotorhomes For Sale - Free Want Ads</u> (132,487 visits to this link)
-
-
Recently Browsing 0 members
- No registered users viewing this page.
-
Forum Statistics
12.9k
Total Topics121.7k
Total Posts -
Gallery Statistics
3k
Images12.9k
Comments362
Albums