suther Posted September 14, 2017 Share Posted September 14, 2017 I need a cold start injector for the 22-RE. Does anyone have a clue where to find one? Quote Link to comment Share on other sites More sharing options...
DanAatTheCape Posted September 15, 2017 Share Posted September 15, 2017 should be no problem to get one. They are common parts. Have you checked Rockauto,com/ Autozone.com etc etc? BTW, what makes you sure you meed a cold start injector? They are just an injector - and injectors are tough parts. If you have it out, it is easy to test it yourself. Quote Link to comment Share on other sites More sharing options...
linda s Posted September 15, 2017 Share Posted September 15, 2017 Not that easy to find. Discontinued by Toyota and the only aftermarket one I could find has also been discontinued. Very odd. He's a remanufactured one from Ice Engineering http://www.lceperformance.com/OEM-Re-manufactured-Cold-Start-Injector-22RE-Earl-p/1062063.htm Linda S Quote Link to comment Share on other sites More sharing options...
DanAatTheCape Posted September 17, 2017 Share Posted September 17, 2017 I would test that injector myself - a 9v battery, a can of spray carb cleaner and plastic tubing is all that is needed. As for replacing it, I would think any injector that will fit the hole might work - all it does is add a little fuel upon cold start up. There are numerous utube videos on how to clean / test injectors.... Quote Link to comment Share on other sites More sharing options...
Maineah Posted September 18, 2017 Share Posted September 18, 2017 On 9/17/2017 at 6:43 PM, DanAatTheCape said: I would test that injector myself - a 9v battery, a can of spray carb cleaner and plastic tubing is all that is needed. As for replacing it, I would think any injector that will fit the hole might work - all it does is add a little fuel upon cold start up. There are numerous utube videos on how to clean / test injectors.... That's pretty much correct it only squirts on a crank signal and it's full tilt. The tip length may have some effect but doubtful. You would need one that accept the screw in fitting. My guess because they were designed for the application makes them expensive very low useage unlike a engine injector. Yes a battery will open the injector that would be a good time to inject a bit of compressed air to the fitting. Conversely you can remove it leave the flex line on and have a friend crank the engine and see exactly what it does it should produce a mist not a squirt no smoking! If nothing happens then you have a delama is there no signal or it the injector toes up? You should be able to feel a "click" when voltage is applied. Quote Link to comment Share on other sites More sharing options...
DanAatTheCape Posted September 18, 2017 Share Posted September 18, 2017 the injectors on my 6 cylinder squirt a stream. It does not squirt directly into the cylinder, neither does the cold start. yes, a 9v battery will make it click. using a hypodermic syringe (without the needle) full of carb cleaner, you can see the stream it produces. It will confirm that it is somewhat functional. have you put a multimeter on the leads to your cold start injector to see if it is getting a command to operate? Quote Link to comment Share on other sites More sharing options...
suther Posted September 19, 2017 Author Share Posted September 19, 2017 Thanks to you all. We tried everything, but it was just no good. But I found a used one on ebay. It works and i'm on the road again!! Quote Link to comment Share on other sites More sharing options...
DanAatTheCape Posted October 2, 2017 Share Posted October 2, 2017 great! Quote Link to comment Share on other sites More sharing options...
5Toyota Posted December 21, 2017 Share Posted December 21, 2017 (edited) up date on this topic seems to be no problem getting these new napa auto parts has a bunch . but there site calls them cold starting valves. about 100 dollors as far as I no these are new. I just bought the plug in for the 22re . and wired it to a old time starter butten. this is on my 88 4wd xtra cab. as far as I can tell my cold start c.ercuit has died no power to the injecter . will use it as a primer butten so far is starting up now at 20 degrees.near impossible to start below 40 deg before . wired direct to a line fuse to the battery . Edited December 21, 2017 by 5Toyota edt Quote Link to comment Share on other sites More sharing options...
linda s Posted December 21, 2017 Share Posted December 21, 2017 2 hours ago, 5Toyota said: up date on this topic seems to be no problem getting these new napa auto parts has a bunch . but there site calls them cold starting valves. about 100 dollors as far as I no these are new. I just bought the plug in for the 22re . and wired it to a old time starter butten. this is on my 88 4wd xtra cab. as far as I can tell my cold start c.ercuit has died no power to the injecter . will use it as a primer butten so far is starting up now at 20 degrees.near impossible to start below 40 deg before . wired direct to a line fuse to the battery . I can find no such part at Napa online. Only wiring for the valve for about 15 bucks. Linda S Quote Link to comment Share on other sites More sharing options...
5Toyota Posted December 22, 2017 Share Posted December 22, 2017 (edited) saw them on the site for the Yakima napa but took me a while to find them will try to get a part number update part no is CRB 218827 price is 162.99 had to switich to not fitted universal fit on there site looks same as both of my 22res Edited December 22, 2017 by 5Toyota Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.