acudoc

thanks for the pic. Do you have an interior one too.?

Can you post a picture?

Drats now I have to get new seats! They look great.

Drats now I have to get new seats! They look great.

I replaced my stove/oven in a sunrader with a countertop stove. It freed up spacxe underneath and they have higher btu burners than most. Often find them on ebay too. Henry

I got the 3 light bargman on ebay for $25. They had several in black. Actually they were a little more on ebay and I wanted 2 so I called and they gave me a discount. All new and very bright. Henry

Electric heaters are 1500 watts max. not 5500 house breakers are usually 20 amp equals 2000 watts.

If you find the ac 110 wire for the air conditioner you can tap unto that to run your vent. Just reconnect it at the power center from 110 to one of the 12 volt fuses. I did it on mine. Easy solution. for the center vent area. In the rear you can remove the vent and drill or push your way to the nearest light for power. Henry

As for the oil, I had to bring my own to the dealer. 20/50 high mileage. I have only 43,000 but was burning some oil even though it had regular 3000m changes. Now no more oil burning for 3,000 miles. The rep said and he was right that would fix it. Even with low mileage everything is older, seals etc. So I use high mileage oil.

thats what winnebago told me to do also. I dont remember why but instead I cut out the drain valves leaving as much pipe as possible and got some washing machine hose and some clamps. No more leaks. Henry

I leave my dog if absolutely necessary but only if it doens't feel HOT for me. I also have a powered fan that I put on when I am gone, and of course WATER. My dog loves her comfy place in the RV much better than in the car. Henry

try rv holding tank sensors on ebay. There are some for $8 plus shipping. There are also some screw in type. Henry

Very nice job. But now they look so good you need to fix everything to match

Yep those are the ones I have too. They are great. easy to install and bright, waterproof too.

as long as you use lights with 3' width center holes you will be ok. i assume you mean the running lights. You can use any type you want. Just saw one over the weekend that replaced the thin sunrader type with larger ones. I got mine on ebay, they came with 2 pig tails, so no soldering. water sealed. just use putty tape under them and any wires etc that stick out behind them are fine, buried in the putty. I have done this to 2 rigs. Henry

Beautiful lights, congratulations.

Beautiful lights, congratulations.

Your solution looks good. For those of us not so soldering inclined. I bought new Bargman 84 triple lights on ebay. $26.50 each when I asked for a discount for 2. Used butt splices that I crimped. Now I have new tailights. Much brighter than before, and they also look new. I will have to change the bulbs when they blow. PS I got the three reds too so now I have 2 running lights instead of 1.

I would suggest getting another unit. Kyocera panels are currently very cheap. Do a search. Also the charge regulator on the harbor freight is poor. You want one with PVM ability. As for watts 50 min 120 or so if you want TV etc. If you decide on the harbor freight make sure to use a coupon. Good luck. Henry

We are having a rally (second annual) and there is 1 spot left in the group area. $30 for 2 nights $40 for 3 nights. Hot springs and good people. If you want to stay alone you can reserve online and visit us. Email me for more information. Henry

Buy IT ! 4 cylinder 5 speed is ideal. I had one. 7 new tires. $700.

When my rear ladder pulled out I used aluminum diamond plate. cut it about 12x6 to spread out the stress. screwed that into the wood I put behind it then attached the ladder. I should work for the awning too. Henry

Tip: click inside this box to load the editor

Look for a wave 3 heater. No electric need. Just tee off your gas line. Henry