Rear axle bearings and seals

[83 Ranger]

Just replaced the rear axle bearings and seals on my 83 Gran Sport Ranger The job for the most part wasn't to bad I did have to make a quick and dirt set up to press off the bearings But other than that it went pretty smooth Defiantly not a fan of the rear brakes they were probably the worst part of the job Anyhow here's what I made to press off and on the bearings if anyone was looking for an easy cheap way  Made it out of some 1.25" strap i had laying around  

[IdahoDoug]

Nice stout way to do it.  Wish I could weld....

[83 Ranger]

Mig welding is easy to learn Once you get the setting set you just pull the trigger and make little C's and a little practice