Kane

Phillips Daytime Running lights LEDs. eBay 100.00 Flushed into plastic grill 92 Itasca Front Hitch receiver for bike rack, or basket or hammock chair set up

How did this trip go for you? Any suggestions etc.

I fabricated 12 inches wide 2 inches tall and 1/4 inch thick aluminum backing plates that I screwed into the RV with stainless screws. My Camco ladder screws into the aluminum with threaded stainless screws and lock washers If I ever need a new ladder I just unscrew the ladder to the aluminum and I'll never have to bother the initial screws into my rig.

Sorry if it's been asked before I'm on cell phone and it's hard to navigate. I'd like to have my motor and trans completely redone and a few upgrades but need somebody who is detailed in this for RVs as I'm not. Thank You Kane

Anybody have any pics of this modification? Thank You

Thank You Sir. Appreciated

My Rig has 2 converters in line with each other before the muffler, is this normal? I feel like it's making my motor run a little warmer than with 1. Please reply and let me know what your thoughts are Thank You If you have recently replaced yours, post a link where's a good place to buy online, also the Flanges and Gaskets. Thanks

You mention a front height change. Did you raise the front suspension? Thank You Looks Great.

West Zmarine sells really nice Marine grade wire looks like Romex but is obviously for outdoor exposed.

I replaced mine with LEDs and they are bright I used a piece of aluminum 1/4 inch thick by 5.5 inches long and 2 inches wide. I mounted my lights to that first then I mounted the light attached to aluminum backer to the RV I tapped threads into the aluminum that way I just unscrew the lights from backer instead of the fiberglass. No more loose fiberglass holes again. I'd post pics but I can't figure out how?

Deet bug spray works awesome for making lenses clear again

I sanded down carefully the rectangular housings and sprayed them with epoxy paint to give them strength. I also used that round rubber wire that holds screens into the frame tracks as a gasket in the channel of the bases. I bought all new stainless screws I purchased new light kits in LED from Bargman that fit perfectly. They are really bright at night love them. I also added a 3rd square brake light at the top rear of RV by running wire into the closet. Also an LED by Bargman. You will also need a Resistor (2) for the hyper flash that happens on the blinkers from LEDs.

I just installed kit 57113 air lift on my 92 Toyita Itasca Took 2 hours. With 40 pounds in I came up a whole inch, can run up to 100 Great add on.