Jump to content

Bigdog

Toyota Advanced Member
  • Posts

    121
  • Joined

  • Last visited

Everything posted by Bigdog

  1. Thinking of replacing my RM641 with a 8 inch taller RM 2510 in my 1984 Sunrader will l eliminate storage above smaller RM461 has any done this and will the larger one fit in the back?
  2. Freezer working fine, main compartment cooling blade's not cold enough to keep food from spoiling
  3. Turn signal stopped working,is it connected with the emergency flashers?they work ,checked all the fuses there goodis there a separate flasher for the turn signal located some where.
  4. Installed all new LED tail light set up, includes brake, turn and back up every works great except that tail lights won't turn off. I used superbright three wire fixtures, white, red and black?
  5. How do I set the tension On new freezer door springs
  6. "Help" I'm in the middle of replacing the tension springs on my RM461 freezer door. How do I set the tension to keep the door shut tight?
  7. Mechanic tried putting bushings on springs, no problem on passenger side said black tank in the way on drivers side, do we need to drop tank to install?
  8. Ice in freezer thick on all surfaces pushing freezer door open, is this a need of a new freezer door gasket if so were do I get one?
  9. I have a 1000 watt inverter and two 12 volt deep cycle batteries, any advice on brand, size volt greatly appreciated. 21ft sunrader
  10. Thanks Linda, Ordered kit then was notified it may require drilling of frame, my mechanic that was going to do the install can't or won't drill frame, so know i have two repair problems I don't have the ability to do the work myself, also I'm having the ty rods and other steering components replaced, and also need the rear spring bushings replaced. so I need a mechanic to do the air spring and bushing install, and find a shop that can do an alignment of the front end. if any one can give me recommendations for the L A ,Orange county area it will be greatly appreciated. Bigdog
  11. Love the frames, where can I get them my 85 Sunrader taillights are worn out and half of my clearance lights don't work. Bigdog
  12. Went to order kit# 57113 found out it is for front Kit #59502 is for rear, max is 2000 Is this the best I can get? Didn't seem like enough for my load and old springs?
  13. Axle housing seal leaked causing bushings and what ever else to wear causing noise and vibration been told it's a major repair job, any advice on where I can get it done in the Ventura, L A, Orange Counties area and general cost?
  14. Any one have wiring diagram for 1984 Sunrader built late 1984 0n1985 Toyota
  15. has any one replaced this setup with led lenses,is it possible? unable to find good original size taillight assembly bulb holders loos and cordoned lenses broken.
  16. Also noticed that there is no temperature change in frig or freezer when thermostat setting is turned from 4 to max? freezer is cold enough to make ice cubes.
  17. No suction, doesn't seem to be as tight as old gasket. moisture is all over, even on front of freezer door, mounting tape is starting to release.
  18. I have a1984/85 sunder can't find short in power source to driver side rear tail light all lights are on and flash with turn signal.ran new power source with toggle switch have to use to turn on brake light on right side and turn signals for daylight driving, does anyone have a copy of wiring diagram.
  19. Replaced old gasket with New according instructions but still have heavy moisture?
  20. WANT TO MAKE SURE I DO THIS RIGHT, HAVE NEW GASKET AND TAPE, NO DIRECTIONS?
  21. Have new gasket, any advice on removing old one and installing new before I Start?
  22. Just noticed remains of what appears to have been a door latch on the top and bottom of the open side of the door it is a small plastic plug that fits into a hole in the top and bottom of the door with matching holes in the top and bottom of the unit, when I push on that side of the door even when locked for travel there is a lot of play on that side?
×
×
  • Create New...