hamkid
-
Posts
385 -
Joined
-
Last visited
Content Type
Events
Profiles
Forums
Gallery
Posts posted by hamkid
-
-
I wanted an impact wrench so I wouldn’t have to struggle with the rusty bolts. I didn’t want to be in a situation where I couldn’t remove a part. Now I’m questioning if I should even start this project.
-
-
-
any suggestions for which impact wrench to buy? I want one that I know will finish the job!
-
Is it ok to have all sides on jack stands or do I have to just work on one side at a time?
-
Can a vehicle get damaged from being on jack stands for extended periods?
-
returned the jack from harbor freight. Found this on Craig’s list for $50. Let’s try this again!
-
That’s exactly what it did right out of the box, jacked up the front end half way then falls down. I added fluid and now the handle just keeps spinning without getting tight.
-
The instructions said to top it off and it wouldn’t even jack up my Corolla at first.
-
I bought a 3 ton harbor freight floor jack today. Topped it off with oil and now it does not tighten. Is a 3 ton jack adequate? I’m going to return it and find a used one on Craig’s list.
-
-
Starting suspension and steering overhaul. Any tips or advice is appreciated. My first question is about loosening the rear wheels. Just to be clear I loosen only the driver side rear clockwise?
-
How much did it cost? I’m considering going there.
-
With that technique would I just screw thru the existing screw holes? What do you think about trying to put bolts thru the existing screw holes at an angle and hoping they hold?
-
It’s for sure rotted, I just don’t care to replace anything right now. I came across the other post with the strap and glue technique and thought maybe glue would hold it up.
-
Would the 1985 escaper use these same parts? What about the front suspension?
-
cab over is sagging on one side. WME made a suggestion on a different post about the fiber glass siding (see link below). Would the same technique work to hold the cab over sag?
http://toyotamotorhome.org/forums/index.php?/topic/11397-siding-separation/
-
Do you think this method would work for the cabover sagging on one side?
-
Upon further inspection I found these near the water heater.
-
They are under the sink cabinets in between the hot water heater and shower room. The sink water lines are coming from the top into those lines you are seeing. The pictures I just posted are in order. After the part that is broken the lines go into the wall of the shower room. I will have to take a look on the outside and take more pics.
-
How do I remove the broken “T” ?
-
How do I remove the broken piece? I can turn it by hand 1/4. Are these some sorta drain valve? I need to get my water running please Help!
-
Need to fix water lines. Should I replace all or the section that is broke?
-
Ha never mind, arrived today. Fits its just not the original style. I will order more.
Thanks Linda!
1985 Escaper full suspension and steering overhaul tips, tricks, and questions
in Engines - Transmissions - Drive Train - Suspension - Chassis - Steering - Exhaust - Tires - Etc.
Posted
Thanks for the inspiration. I welcome all input and opinions. Please do not hesitate to post what you think, it’s impossible to offend me, but will always cause me to over think.
What size breaker bar should I purchase?