bobar

has any one used eternabond to seal the side seams on a metal body Toyota (four seasons) and did you remove the old silicone and did you have good results? thanks bob

just got my rv back from being worked on and discovered that i was wrong about the compression numbers should be 120,100,120,120. does this change any ones thoughts. The rv runs good and i have climbed some big mountains for arkansas (2700 ft) with no problems. i have drove about 2000 miles i don't know how long it may of set up. thanks

i have an '85 22re with 2600 miles on it using about 1 qt of oil every 500 miles had a compression test done 140,135,100,140. I have been told i may have a or some stuck rings. I have been told that i can take the plugs out and soak each piston with marvel mystery oil over night (crank the motor over with the plugs out then put them back in) then change the oil and add a qt of mmo run it for 3000 miles and it may fix or help it. Any thoughts about this thanks!

has anyone tried to mount a scooter on the front or back of one of these rv and if so what size scooter and how did you do it. Thanks, Bob

i am replacing the valve seals on my 22re motor. I have been told that you can put air pressure on one cylinder at a time and replace those two seals,if you do it that way you don't have to pull the head. Any thoughts you may have on this would be welcomed.

I just got my 85 four seasons on the road and took my first trip brought scrap 2x4's to use for leveling just wondering what other people use.

my rv has a central power pack made by carson. Does anyone have a manual for it or do you know where i can get one. THANKS, BOB

Thanks for the info. Bob

Onan micro2800 generator cleaned carb will only run at slow speed if I try to power anything up it will die. I have checked filters had very little trash in them any suggestions.

Does any one have a manual for a 85 four seasons? Thanks, Bob

I finally got my 6 lug axle in and got me some new tires. I would like to thank everyone on the site for helping me. I will see if I can get my wife to take a picture so we can post it.

it's about the same size as the one that is on it now so it must be for anti lock brakes. Thanks, Bob

I finally got my axle and every thing looks like it will match up however there is an electrical connection on the yoke end I think it is a hookup for low and high range gears. Will this automatically be in high gear or will I have to change it? Thanks, Bob

will the yoke and shock mounts on the 92 1 ton axle match up with my existing ones. (ei 85 model).

that was the only place i could find one that had wheels and axle and could ship it to me, it's being shipped today it cost me 1100 shipping included. that was the best deal i could fine. Thanks again Bob