LittleShack
-
Posts
120 -
Joined
-
Last visited
Content Type
Events
Profiles
Forums
Gallery
Posts posted by LittleShack
-
-
I thought I would avoid fitment issues and went with the actual toyota part "Toyota 90916-02196 V-Belt" lol....which is the one I am having the issues with now....
-
seems no matter what I do this belt wont tighten up enough..I changed it recently with what the auto parts shop gave me, tightened as per proper procedure and now after a few thousand miles it seems stretched somehow???..the pump butts up against the engine and does not allow me to tighten the adjustment further???? I am wondering it I can get a slightly smaller belt??? any ideas????............THANKS
-
I'm wanting to add a couple of the usb/12 volt cigarette type outlets to the RV. I have watched a ton of videos on different ways to add them and think the simplest is tying them into the wiring for the 12 volt lights under the cabinets. What is the general opinion on this way? I also have a very long wire that goes to a cigarette lighter outlet from the DC power fuses. A previous owner installed it and it does work, but I am a little leary of the long wire so would like to install another of the usb/12volt outlets on the wire and install it close to the electrical panel. As I'm looking at the panel, and seeing a bunch of unoccupied fuse 'slots'. I'm wondering if it would be better to add a new fuse, if that is even possible to connect the outlet to, instead of the way the previous owner connected it which it to the same circuit as the furnace. Not sure how I would do this-adding a new fuse. Anyone??
I've attached a photo of the DC fuses with the yellow arrows showing the black wires that connect the cigarette lighter outlet. The one on the left connects to the furnace fuse. You can see the empty fuse 'slots'
-
On 9/4/2019 at 5:51 AM, Maineah said:
Hate to tell you this no matter what you do the Kohler it will never be quiet. The Onan is quieter but not what I would call quiet either. Part of the problem is the speed they have to turn to make 60 cycles AC a two pole generator has to turn 3600 RPM to do that. Onan made a larger unit for big MH that was a twin cylinder it had a 4 pole generator and only turned 1800 RPM it actually was as quiet as a little Honda but BIG!
Yikes! Glad I have a Yamaha too then!
-
On 9/4/2019 at 7:25 AM, wemit said:
I don't know where you plan on going in Montana but if you get to Kalispell, go to Gardiner's RV. They have an excellent service center and can probably help with your generator.
Thanks! Good to know!
-
Spent an hour searching for a photo of a generator that looks like mine....finally realized...DUH!....it's a Kohler, not an Onan. The Onan is in our travel trailer.🙄
It looks pretty much like this.
-
8 hours ago, Derek up North said:
I'm guessing one like this. (WARNING: Hearing protection recommended!)
Not in mine. I'll be heading home in a few days and can get the numbers then. Mine looks pretty different to this.
-
4 hours ago, fred heath said:
Google “scooter mufflers “. They’re small, inexpensive and can be modified to fit your genset. The alternative is to order a replacement muffler from Onan ($$$).
I knew someone would point me in the right direction! Off to 'google'! Thanks!
-
I am visiting family and am away from my '92 Itasca. Last spring we began looking at the built in generator, which runs great, has only 23 hours on it, but is noisy as heck! The muffler on it has all but rusted away.We tried repairing it with various tapes, tubes and what not. It didn't take. So, am now looking to replace it if possible. I will be travelling to Montana this month from BC, Canada, if anyone knows of a US business I might find one at, or here in Canada will work too. It is an Onan, but I couldn't tell you which model without going out to look at it. Thanks for any help you might be able to give.
-
-
I know this can be done on other rigs, but as the regulator on my built in tank is right next to the shut off, I'm not sure if it is possible to add a T connector to the line. I'm wanting to be able to use a propane fire pit while out and about during fire ban season, which seems to be most of the summer now. BUT, I don't want to have to bring along the extra tank due to space and weight issues. Has anyone done this? Thanks!
-
I think I would have spotted the frayed belt if I’d thought to shut it off while looking🤪
-
Just to bring all you very lovely helpful people up to date... my husband thought the same about the transmission shop. He asked if I’d mind waiting around in Tucson til he could get down here and look at it himself. Which I had no problem with. He arrived a week and a bit later and I just stayed put at the Desert Diamond Casino parking lot. Anyways, he opened the hood and right away noticed the frayed alternator belt. Then noticed a big bolt about to drop out of its hole!! Literally!!! He was able to replace the alternator belt and another belt he had to remove to get the alternator one on. Got that bolt back in and tightened a loose clamp. No more noise!!! So glad I have a handy hubby! He’s been such a great sport about helping me with this old gal.
Thankyou all who offered suggestions and ideas.
Took it to the tranny shop for a flush, which it didn’t get cause it didn't need it.
They were very nice, but I didn’t spend a dime there, but did enjoy 2 cups of their coffee and found out where to take my dogs for baths! So, not a total waste of time😉
-
Just out of the aamco transmission shop. The transmission is fine. They figure the noise is either the fly wheel or torque converter. They will have to remove the transmission to know which and can do that Monday morning. They are letting me stay in their patking lot, which is nice. Anything I should be looking out for with either of these prognosises?
-
Nothing loose that I can see (or shake) underneath. I've got an appointment tomorrow morning to get the transmission serviced (fluid, gasket and filter). We figured it was a good idea regardless. So, if it is the tranny, maybe this will fix it, or they may see what the problem is when they are there.
-
WME... I will do just that. My husband, who is currently many, many miles away... had also been trying to help me. He thought it might be the transmission fluid. He asked uf it smelled burnt. It stinks, but not burnt smelling. It was flushed in 2012 by pevious owner. I had the timing belt replaced Dec of 2017, under the warranty. They also replaced the water pump, idler, knock sensor, timing belt, camshaft seals, crankshaft seals... they removed the exhaust manifold and had to replace 6 exhaust manifold studs due to corrosion. The knock sensor sub harness was very brittle and they had to wrap the wire with electrical tape as it was bit an easy part to replace. It was successfully installed this way, but... possibly hasn’t lasted?? The valves were also adjusted. Since then, I made a trip from BC down the Oregon coast and across BC and back. Now, after driving from BC to Tucson, it’s making these rattly noises. Figures its when my hubby isn’t on hand to figure it out😥
-
I was able to leave it in drive with the park brake on and tried to localize the sound. It seems to be coming from the middle front. It sounds more like a clunky rattle than a shakey rattle. Hard to explain.
-
-
-
I tried, but it doesn’t make the rattle when in park. I’m on my own, so don’t have anyone to sit with it running in drive.
-
I’m in Tucson, Az and after sitting parked for 2 nights, went off to do fills and empties. I noticed a quiet knocking noise while at stoplights. Stops when I put it in park though. It is not a regular knock. Kind of a few knocks and a pause, then again, repeating. I’ve checked the oil, which, hot, seems fine. I’m here without my husband, so would be at the mercy of any mechanic I checked it with. Any suggestions on what to look at myself? Or any recommendations would be greatly appreciated. I’ve driven from BC in Canada, and it’s just warming up here, so am wondering if it is temperature related. Thanks for any help!
-
Thanks everyone!
-
Can anyone tell me how these RVs handle in the snow? I am trying to avoid this, but in case I am stuck, how do the duallys handle the snow? I have lots of snow driving experience in trucks and cars, but the RV is a whole other beast. Are chains a good idea? All season tires? Thanks!-Sue
-
I posted a new video today! Hope someone can use the info!
Problem...1992 power steering belt too loose...
in Engines - Transmissions - Drive Train - Suspension - Chassis - Steering - Exhaust - Tires - Etc.
Posted
thanks for the ideas....the belt is marked with toyota and the part # and moving the pump away further loosens the belt but again thx for the input...all i can think of is a smaller size belt but even a wider one would help