Jump to content

justinc25

Members
  • Posts

    7
  • Joined

  • Last visited

Posts posted by justinc25

  1. You certainly have your arms full! Got to be a great way to stay busy!

    Another possibility is vinyl mini blinds. Lowes and Home Depot can cut them to width but its up to the customer to shorten them though.

    This is actually what I did in my '86 Dolphin. $40 for 10 mini blinds. Then you just need to shorten. Not too bad to do, you can acomplish this with a steak knife, a pair of scissors, and a lighter.

  2. Thx for the feedback all.

    First of all when i bought it, it only had 13,000 miles. It had been sitting awhile in someones yard. Here's what i've done so far: changed the fuel pump, fuel filter, air filter, alternator, spark plugs, wires, distributor cap and rotor, belts, had all the fluids drained and replaced, except for the transmission and clutch oil. My idle seems a little high but when i take it down a notch, it's too low that it dies. I did suspect maybe there is a compression issue, I'll check that next, or maybe look into the carburator too.

    I was thinking of doing the fast and dirty K-seal solution to eliminating the white smoke instead of tackling the head gasket right now, since i'm on the road. Has anyone tried this?

    Most shops, and some parts stores have a tester that mounts inplace of the rad cap that will test for the presence of hydrocarbons in your coolant indicating a head gasket. Is the white smoke all the time, or just when cold ?

    There very well may be a problem with your head gasket, or it could be ok depending on what the test shows.

    At any rate just wanted to address the fact that it won't have much more power if it is running in top shape.

    My '86 Dolphin with the 22-RE and Auto Trans, struggles to maintain 60 mph, 55 up hills here in New England.

    As much as we love these motorhomes, they are underpowered especially with the 4 cyl and the auto.

    Sometime ago I had a '83 Huntsman with a 22-R and a 4 spd, and it had about the same power.

    The EFI gives you a little more power, but any gain is lost in my Auto trans. That said I could get my Huntsman up to 65 Mph but it wouldn't stay there.

    I've been debating putting a cam in my Dolphin to try to boost torque a little bit. I think if it had a little more, it may be able to maintain speed. It also feels like it is geared way too short. Sorry for the long winded response, but back to your last question.

    Normally I would be very weary of using a product like a block seal, but if you have it tested and it is a head gasket, Your gonna have to pull the head anyway, (Don't forget the secret bolt in the front under the puddle of oil when pulling the head) so give it a shot.

    Best of luck,

    Justin

  3. Bleach is the best mold killer, but it will wreck the fabric. You can buy mildew stain remover at some supermkts or you might go on line at some other sites.............Tony

    I made a bleach/water mixture of 1 tbsp bleach to 32oz water for the door panels, and seat belts that have mold. It seemed to work well, tomorrow I'll know if it will discolor. I think I'll try it in an inconspicious place. My major concern is the sofa. The table cushon covers come off, and I can wash them, but not so with the sofa.

    Thanks for the quick reply,

    Justin

  4. Hey guys,

    I'm getting ready for a trip next week, and pulled out my '86 Dolphin today.

    I just noticed some mold has formed on the sofa bed, and the seat cushons at the table.

    Anyone know how to remove this without hurting the fabric ?

    My interior was perfect before this happened. I had found a couple leaks from the winter, but have fixed them.

    I'm a little short on cash, but if necessary I might rent a upholstry machine from home depot.

    Any help will be greatly appriciated.

    Thanks,

    Justin

×
×
  • Create New...