[Sunrader Appliances Looking For Good Home]

Anyone near western New York need any appliances for parts or repair? We gutted an 87 Sunrader and are replacing/upgrading most of the appliances and I would hate to scrap all of these. The following is from a craigslist ad I posted but got no responses to:

 

RV Appliances pulled from 1987 Toyota Sunrader. See descriptions and photos for condition. We were told all of the appliances were working when we bought the camper but we didn't have access to a 30 amp hook up before we gutted the interior and so cannot guarantee the function of some of the appliances. Because of this we are listing all of the appliances as is. Please see condition in photos. If you see something you are interested in please Make An Offer.

4 Burner Stove with Oven
All burners fully functional. Haven’t tested the oven. Comes with overhead exhaust in working condition.

Dometic RM2400 3 Way Fridge 
All parts and accessories are present but the fridge didn't get cold after a couple of hours plugged into a garage outlet. Not sure what the issue is as the previous owner said it was working but listing it as is for parts or repair.  

Coleman Roof Mount Air Conditioner Model Number 67270709 
Again was told this functioned when we purchased the RV however without access to a 30 amp service we never tested it. Listing it as is for parts or repair. Comes all interior and exterior parts needed for install.

Electrical Panel
Main fuse box from Toyota Sunrader. AC/DC power distribution. Fully functional.

 

 

[Question About Sunrader Roof]

WME, when you say a 1” curve do you mean a 1” drop from the center to the edge? As in trace out an arc that starts at the center of the 2x4 and drops 1” to each side?

[Question About Sunrader Roof]

Linda, thanks for the reply. I was afraid that might be the case. At the moment I’ve got the ceiling jacked in the center of the ceiling using a roughly 2’x2’ piece of plywood to spread the load. I’ll try swapping it for a piece closer to the full width of the ceiling and see if I can’t get the edges up a bit more. 

[Question About Sunrader Roof]

Have a question about re-arching the roof on my 87 Sunrader.  I have a sagging roof that I need to raise.  I jacked the roof up under the AC area until it started creaking, at which point it looked like it more or less matched the arch at the front and rear of the roof.  However when viewed from the exterior there is still dip at the edge of the roof line.  My question, having never seen an original roof, is whether that dip is supposed to be there or whether I need to jack further.  I have attached some pictures to help clarify what I mean by the dip.  Thanks for any and all help.