alexcarey Posted September 30, 2015 Share Posted September 30, 2015 hey all, new to the board here. Hope this is in the right section. I just purchased a nice little 84 dolphin. Everything seems to work so far except I can't get the accu have panel to light up and give me tank read outs for levels. I tried calibrating and had no luck. The water pump switch on the panel works fine however. Could it be the 30 year old lights have burnt out? Thanks in advance. Cheers Quote Link to comment Share on other sites More sharing options...
jjrbus Posted September 30, 2015 Share Posted September 30, 2015 Welcome to the forum and the Toy madness. I have found the tank monitors not worth the effort to repair and do not use them. A flashlight held up to the freshwater tank will show the level and the light shinned down the toilet will do the same thing. Not for everybody, but works for me. Jim Quote Link to comment Share on other sites More sharing options...
Maineah Posted September 30, 2015 Share Posted September 30, 2015 Yeah at best they are all most worthless brand new. The only ones that really work are aftermarket See Level gauges. Quote Link to comment Share on other sites More sharing options...
alexcarey Posted October 1, 2015 Author Share Posted October 1, 2015 Good to know, I'll check through the throne. And I guess for grey water just drain it when you fill it and you'll have no problems. If I'm having an issue with the deep cycle should I post that in electrical section or appliances? Thanks guys for your quick responses! There's life on this forum after all! Quote Link to comment Share on other sites More sharing options...
5Toyota Posted October 2, 2015 Share Posted October 2, 2015 I have friends with almost new pull behinds and they still say two three years old don't work already. my 78 didn't have any. don't need them now on the 87. carry a good flashlight use for all things LOL. goes bad throw it out and for 5 bucks replace it. Quote Link to comment Share on other sites More sharing options...
Vanman Posted October 2, 2015 Share Posted October 2, 2015 We must be lucky ours worked from day one and still does. One thing is you do not get the top lite on the voltage check unless you are charging the battery. But a careful reading of the fine print (hard to see with my old eyes) is the second from top is full for the battery check. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.