altheim

I recently notices a leak (a drop every 3-5 seconds) underneath the escape vent frame when it rains hard. I have tried to reseal around the frame on the outside as well as check the top of the vent to no avail. Any advice of how I can find out where the leak comes from is much appreciated. Thanks in advance.

Thank you for your reply. There is a ASME labelling on the tank. How long can this type of tank be used safely?

I need to replace the RV vent lid with dimensions 25" by 18". Could you recommend a place where I can get one? Can this be installed easily? Thank you

I filled up my horizontal propane tank fill up last week and the attendant told me that the propane tank is rusted on the outside and he won't be be able to refill it next time. I have a 1991 Odyssey. I think it is an original tank. How long does the propane tank last? Do I need to replace it? If it needs to be replaced, could you recommend a place in Seattle vicinity? What would be the cost for tank and installation? Thank you Joe

Hi, I have a 1991 Odyssey and I am in need of the hood hinges. My passenger one is broken. Any one have any suggestions where I can buy or know where I can find them? Also wondering if I should replace both or just the one broken. Thanks, Joe

Hi, I was wondering if anyone has encountered the following problem: For the past three summers, I had difficulty pumping gas in the fuel tank when I am travelling at a higher elevation (Glacier , Yosemite, and Yellowstone national parks). On these occasions, the gas keep spilling out indicating that the gas tank is full. The only thing I could do is to pump gas very slowly (and this usually took 10 minutes and it is a pain!). I did not have difficulty pumping gas at the beginning or at the end of the trips when I am at lower elevation. Also, I do not have any difficulty pumping gas when travelling on trips at lower elevation. Has anyone encountered this problem? Is there a solution?

My Toy's rear leaf spring bushings and shackle bushings need replacing. Just wondering if anyone can suggest a place in Washington (Seattle, Burlington, or Bellingham along the I-5 corridor) and Vancouver, BC that will be able to do this job. Also wondering what the estimated cost would be. Thanks for your help.